
A Compact Upright Block
At 10 cm wide, 20 cm high and 10 cm deep it is a compact upright block rather than a wide sconce. That proportion suits a narrow pier, a door reveal or a run of piers along a facade where a broad fixture would crowd the surface.
Nine Hundred Lumens, Up And Down
Nine hundred lumens go up and down the wall rather than out into the garden. The beams graze the surface, picking up the texture of brick or render, which is what makes a plain facade read as lit rather than simply bright.
Sealed And Left Alone
The body is sealed to IP65 for fully exposed positions and takes 85 to 265 volts, so supply variation is not something to check. The LED is integrated into the aluminium, so once it is fitted there is nothing to service.
Frequently asked questions
How is it switched?
From a normal wall switch on the circuit it is wired to. It is a plain hardwired sconce with no app, no remote and no sensor, so it comes on and goes off with the switch that feeds it. If you want it to run on a schedule, fit a timer or a photocell at the switch rather than expecting it from the fixture.
Is there a bulb to replace?
No. The LED is integrated into the aluminium body, so there is no lamp to source and none to change over its working life. The trade off is that you choose the output and colour once, at the point of order, rather than being able to change it later by fitting a different bulb.
Can it go on a fully exposed wall?
Yes. It is sealed to IP65, which means it is rated for full exposure with nothing overhead. A gable end, a garage side or an open facade is fine, rather than needing a porch roof or a deep overhang to get through a wet winter.
How big is it and how much light does it give?
The body is 10 cm wide, 20 cm high and 10 cm deep, so it is a compact upright block on the wall. Output is 9W and 900 lumens, thrown up and down rather than out into the garden. That suits a patio, a porch or a run of piers along a facade, where the beams graze the surface and pick up its texture.
Does it need a special power supply?
No. It hardwires to a standard fixed connection and accepts a wide 85 to 265 volt input, so supply variation is not an issue. The housing is sealed to IP65 for fully exposed positions, and the LED is integrated into the aluminium body so there is no bulb to replace later.



